Home > Molex 2mmJST-SH | Molex Picoblade (1.25mm) | JST-ZH | JST-PH | JST-RCY | 1.27mm | AR6400/PKZ3352 | Power
Molex 2mm Pitch Connectors
| Adapter Leads
| Switch Modules
These 2mm pitch plugs and sockets are ideal for use in limited spaces. The 2 pin versions provide a very small but safe method of connecting and disconnecting LiPo and the 3, 4 and 5 pin versions can be used for balance connections where a JST-XH would take up too much space.
A plug is a male plastic shell with female crimp terminals and a socket is a female plastic shell with male crimp terminals.
Many single and 2S LiPo come fitted with a 2 pin plug. Unfortunately, there is no manufacturer consistency in the way that the negative and positive wires are inserted into the shell. The Micron convention is that negative is at position 1, as shown in the image of a socket at the right. All leads and LiPo supplied by Micron are wired this way - see Connector Wiring for details; please contact us if you need your LiPo or Molex 2mm leads wired with pin 1 positive.
A 5 pack of Molex 2mm pitch plug shells and crimp terminals (each packet contains 5 spare crimps for you to practice).
A 5 pack of Molex 2mm pitch socket shells and crimp terminals (each packet contains 5 spare crimps for you to practice).
All of these adapters use the Micron wiring convention (pin 1 is negative). Please contact us if you need an adapter lead with pin 1 connected to positive.
An adapter lead to allow single cell LiPo with 'UM' battery connector to be used with receivers or ESC that have a Molex 2mm 2 pin socket. The Molex plug is wired with the Micron convention of pin 1 negative.
An adapter lead to allow single cell LiPo with a 2 pin Molex 2mm battery connector to be used on receivers with a 'UM' socket (e.g. the Spektrum AR6410), or to allow the LiPo to be charged with a 'UM' charger. The Molex socket is wired with the Micron convention of pin 1 negative.
A 250mm charge/balance adapter lead with a Molex 2mm pitch plug at one end and a JST-XH plug at the other end plus 200mm red/black bare end wires for connection to a charger's positive/negative sockets. The red/black wires may be snipped off if your charger uses only the JST-XH connector for charging and balancing. If your charger does require connection to the charge sockets, suitable 4mm plugs are available.
The adapter is designed for charge currents up to 2A.
The Molex 2mm connector is used for LiPo charging and balancing where space is tight and there would be insufficient space for a JST-XH. These connectors are used on the Model Rail Wiring Harnesses.
Price: from £2.15
A small on/off switch and charge socket module for model vehicle installation. The module comprises a miniature slide switch, 2mm pin space Molex charge connector and 1.8mm LED mounted on a 25mm x 15mm GRP plate. The wiring comprises a Molex battery connector on a 50mm lead, 100mm red/black/brown wires with bare ends for soldering onto your receiver pos/neg/LED2 pads or splicing onto the receiver lead-out wires. The LED positive wire (brown) has a series resistor for use on 3.3V (Deltang Rx 'P' output).
Price: from £5.65