Click on image for a larger version.
Rx66 DSM2/DSMX 18V Receiver with 4A Bi-Directional ESC
Rx66 is a 2.4GHz DSM2/DSMX receiver which includes one integrated 4A reversable controller for brushed motors (ESC). The motor stall current must be less than or equal to the ESC current rating; this can be increased to 6A using a heatsink. The voltage range is 3-18v for 1-4S LiPo, 1-5 LiFe, 3-12 NiCd/NiMH or 1 PP3.
|Size:||46 x 26 x 4 mm|
|Voltage Range:||3V - 18V|
|Max Current:||4A (6A with heatsink)|
| wiring adds 0.5gm ~ 1gm to the bare board weight |
Rx6x Receiver Features
Rx66 is available as board-only for you to add wiring or with a range of pre-wired leads / connectors. Deltang have advised that a capacitor of approx 200uF should be wired across the battery pads when the receiver is used with a voltage of 12V and above. A suitable capacitor will be supplied loose when the 'no power leads' option is selected and will be attached with any other leads/connectors option. See the More Images tab for a photo of the capacitor in place. If the options below do not exactly meet your needs, please contact us to discuss your requirements.
An enormous range of programming features are provide to enable you to customise the operation of Rx66 to suit your model. See Rx66 v611 Programming for full details. Access to programming is either via a stick type transmitter or using the PROG3 programmer. A selection of program setups are provided as variants (-1, -2, etc.) - view the Variants tab for details.
The receiver is normally supplied as a bare board, with wiring options as specified in the menus below. If you want the receiver protected against accidental contact with metal parts, please select the 'heatshrink' option.
The heatsink is attached to the Rx66 with a non-metalic screw through the hole in the center of the group of ESC devices. If using the heatshrink cover, this must be fitted and a rectangular hole cut into it above the ESC devices before the heatsink is attached - see More Images.
Receiver Variation, Antenna and Wiring Options:
throttle control method applies only to -2 and -22 variants
The receiver has a low-voltage cutoff facility which stops the motor when the battery has reached its discharge voltage. The default setting is for LiPo batteries. If you are using NiMH, the LVC should be disabled - see Low Voltage Cutoff tab.
The cover must be applied before a heatsink is installed as a hole must be cut in the heatshrink cover around the FET devices to enable the heatsink to contact them.
Base Price: £ 45.00
Total Price: £ 45.00
Spare 150mm aerials are available for the extended aerial version of Rx65, Rx66 and Rx102: £ 1.15